[China Glass Net] The curved glass door is a glass door with a curved glass door with a curved appearance. The curved glass door can be designed according to the site conditions, with different arc-shaped glass doors, semi-circular glass doors and arc-shaped curved glass doors. It is suitable for all kinds of high-end buildings such as high-end hotels, hotels, financial institutions, etc., especially for occasions where the entrance and exit is not very large, and it is also suitable for the shower room of the bathroom. 1. Installation of arc automatic door fixing frame: Solid Soft Shell Bonded With Polar Fabrics Poly Fabric,Poly Fleece Fabric,Solid Soft Polar Fabric,Shell Bonded Micro Fleece Fabric Shaoxing Yihui Textile Co.,ltd. , https://www.yihuitextile.com
(1) Six columns are installed according to size requirements.
(2) The column and the cap are composed, and the cap is fixed to the column with screws.
(3) The lower pier is assembled with the column, and the pier and column are connected by angle aluminum and screws.
(4) The upper support assembly is installed, and the beam and the beam are connected by the angle support, and are fixed by bolts and nuts. The beam is connected to the inner wall of the cap and is fixed with angle brackets and screws.
　 2. Installation of flat steel: flat steel is installed on the inner surface of the cap, and the components of the drive mechanism are fixed on the flat steel.
3. Rail bracket installation (installation of curved rail support): Mount the drive fixing plate to the flat steel with M8X25 screw, and install 12 guide brackets for the 1/2 round drive mechanism.
4. Install the circular arc guide rail: Fix the circular arc guide rail to the rail bracket with M6X20 screw.
5. Drive unit and drive wheel installation: Mount the drive unit fixing plate to the flat steel with M8X15 screws, and then fix the drive unit, drive motor and drive wheel to the fixed plate with M6X15 screws.
6. Idler wheel installation: Install the idler fixing plate to the flat steel with M8X15 screws, and then install the idler to the idler fixing plate with M6X12 screws.
Tensioning wheel installation: first fix the processed tensioning wheel to the wheel fixing plate, then fix the fixing plate to the tensioning wheel bracket with M6X10 screws, and then fix the tensioning wheel bracket to the flat steel with M8X15 screws. .
7. Door ring theory: Assembly of hangers and belt fasteners: Each side of the arc door is equipped with a pulley hanger on one side of the upper side of the arc door. On the other side, in addition to the pulley hanger, the connecting plate is fixed with the M4X12 screw on the pulley hanger. A belt fastener is reloaded on the board for the connection of the door leaf to the timing belt.
8. Door fan hoisting: The door leaf is first installed with the door pulley hanger, and then the pulley and the door are hung on the circular arc guide. Adjust the vertical position of the door leaf and the gap between the two doors. After appropriate, fix the belt fasteners on the door pulley hanger and the timing belt. The door leaf is connected with the drive mechanism. Note that the belt fasteners are in the same direction as the timing belt.
9. Install the door stopper: the door stopper is the limit device for opening and closing the door leaf, the arc automatic door is in the state of being fully open to determine the position of the door stopper, the position is set to 9, and the stopper is fixed by screws after fixing. .
10. Install the controller: first install the control fixing plate, then screw the controller to the controller fixing plate.
11. Install sensor and electronic control system connection: install the sensor, power switch and drive motor for each electronic control part connection.
12. Installation of the top plate: After installing all the components of the circular arc automatic door, the top plate should be installed and waterproof and rainproof.
May 31, 2021